Terex TL120 Operating Instructions Manual page 41

4.3.2 Monitoring the machine during operation
Engine damage
due to fault which has not been remedied.
• The fault must be remedied before starting
the engine and operating the machine.
• If the battery charge indicator lamp (10/22) or the
engine oil pressure indicator lamp (10/31) lights
up, switch off the engine immediately and
determine the cause, or call for service personnel.
• If the permitted coolant temperature (10/25) is
exceeded, stop work, open the engine hood and
keep the engine running at low idle to allow it to
cool down.
• Once the engine has cooled down, turn it off and
determine the cause of overheating, or call for
service personnel.
• If the air filter service indicator lamp (10/32) lights
up, perform the necessary air filter maintenance.
4.3.3 Switching off the engine
Attention
Do not switch off the engine when running at
full throttle, but allow it to run for a short time
without load at low idle-running speed.
• Turn the ignition key to "0".
• The engine stops automatically.
Operating Instructions Wheel Loader TL120
25
22
Fig. 10 Monitoring and switching off the engine
Operation 4
31
32
L824-012
41