Terex TL120 Operating Instructions Manual page 95

7.8.16.1 Removing the dust filter for cab
ventilation
• Remove the ventilation louver (65/1).
• Remove the angle bracket (65/2).
• Remove the dust filter (65/3).
• Clean the filter or replace it.
7.8.16.2 Cleaning the dust filter
Attention
Never wash or brush out the filter.
• Knock the filter with the intake side (side covered
by expanded metal) several times on a flat and
hard surface.
• Using dry compressed air (max. 5 bar), blow
against the direction of flow.
• Check the filter for damage to the paper bellows
and seal.
Attention
Never continue to use damaged dust filters!
7.8.16.3 Installation
• Insert new or cleaned dust filter until the stop.
Attention
Observe the mounting position of the dust
filter; the air flow arrows must point towards
the cab.
• Fasten the dust filter with the angle bracket.
• Re-install the ventilation louver.
7.8.17 Windshield washer system
• Topping up the windshield washer tank (66/1) as
required.
• Add antifreeze when temperatures are around or
below freezing.
Operating Instructions Wheel Loader TL120
Care and Maintenance
2
1
Fig. 65 Removing the dust filter for cab ventilation
Fig. 66 Top up the windshield washer tank
7
3
1
L854-062
95