Terex TL120 Operating Instructions Manual page 83

7.8.6.4 Tensioning the V-belt
• Slacken the fastening screws 49/1, 49/3 and 50/1.
• Rotate the generator (49/2) until the tension is
correct.
• Re-tighten the fastening screws 49/1, 49/3
and 50/1.
• Check the tension again.
7.8.6.5 Changing the V-belt
• Slacken the fastening screws 49/1, 49/3 and 50/1.
• Swivel the generator against the direction of
tensioning.
• Remove the used V-belt and fit new one.
• Swivel the generator (49/2) in the direction of
tensioning until the V-belt tension is correct.
• Re-tighten the fastening screws 49/1, 49/3
and 50/1.
• Check the tension again.
Attention
• If V-belts have been replaced, their tension
must be checked again after
approx. 20 operating hours.
Operating Instructions Wheel Loader TL120
Care and Maintenance
Fig. 49 Tensioning and replacing V-belts
Fig. 50 Tensioning and checking V-belts
7
1
2
3
1
83