Terex TL120 Operating Instructions Manual page 39

Wheel loader
Table of Contents

Advertisement

Legend Fig. 8
20 Not assigned
21 ORANGE - pre-heating monitor
22 RED - battery charge indicator
23 RED - parking brake
24 GREEN - travel direction, forward
25 Coolant temperature
26 Operating hour meter
27 Fuel-level indicator
28 GREEN - travel direction, reverse
29 GREEN - direction indicator
30 BLUE - high beam
31 RED - engine oil pressure
32 RED - air filter indicator
33 Travel speed - FAST - SLOW
34 High-gear changeover switch
Attention
Only press if machine is at standstill!
35 Multi-function switch with lock for work equipment
cut-off and change-over of the direction-of-travel
preselection switches from Pos. 7 auf Pos. 36
Machine damage
due to incorrect operation.
Only press if machine is at standstill!
36 Preselection of travel direction - Function only
active if working hydraulics are disabled
37 Not assigned*
38 Not assigned*
39 Not assigned*
40 Windshield washer function front/rear
41 Windshield wiper, front
42 Windshield wiper, rear
43 Switch for air-conditioning and temperature
control
Operating Instructions Wheel Loader TL120
44 Fan switch - heating
45 Not assigned*
46 Option - Preselection switch -
Ride Control System
47 Preselection switch - operation of additional
control circuit (Pos. 5)
48 Preselection switch - float position -
OFF/Impulse/Continuous operation
49 Not assigned*
50 Glow plug and starter switch
51 Hazard warning switch
52 Working floodlight, front
53 Working floodlight, rear
54 Not assigned*
55 Not assigned*
56 Option - 4th control circuit
57 Heater control
58 Monitor - indicator "manual transmission range I"
59 Monitor - indicator "manual transmission range II"
60 Monitor - indicator "manual transmission not ready
for operation"
Attention
If this symbol comes up, the manual
transmission is in an intermediate position.
The machine is not ready for operation! This
can be remedied by performing brief
steering movements until the manual
transmission engages.
61 Speed indicator
62 Option - flow setting for 4th control circuit, e.g.
rotating speed of sweeper
* for non-standard equipment
Operation
4
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents