How To Measure Voltage Ac With The Module Zed7 30-Abx - Ahlborn ZED7 00-ABx Instruction Manual

8. Switch on the consumer.
➢ The measured values will be displayed on the ALMEMO
5.4 How to measure Voltage AC with the
Module ZED7 30-ABx
Cable the system (especially for measuring voltages greater than 50V)
in power-off state. Only switch on the voltage after the cabling has
been set up completely.
To avoid electric shocks, do not touch any exposed parts or
connections during operation.
Use the supplied touch proof connector cables.
1. Switch off the voltage at the voltage source and check that no voltages are
present.
2. Connect the ALMEMO
socket of the ALMEMO
3. Switch on the ALMEMO
4. Using the connecting cables, connect the voltage source to the black
sockets of the measuring module.
5. Switch on the voltage at the voltage source.
➢ The measured values will be displayed on the ALMEMO
5 How to run a Measurement with the Measuring Module
® plug of the measuring module to an ALMEMO
® measuring device.
® measuring device.
measuring device.
®
® input
measuring device.
®
- 19 –