Table of Contents
Advertisement
4 Product
The ALMEMO
Control program (from v. 5.14.0.330) is used for configuration via
®
the sensor menu. In the measuring point list, the 'Sensor menu' can be found
under 'Edit'. Here primarily up to 10 measuring points with the specific D7
measuring ranges of the D7 sensor and further settings can be programmed. The
measuring ranges appear on the interface with new meaningful abbreviations.
Besides the range, a dimension of up to 6 digits and a comment are automatically
programmed and then the channel is locked with 5. Deleting areas is done in the
list by selecting '- - -'.
Function channels are either parameters of the measuring device or are
calculated by the measuring device. They can therefore only be programmed and
used by the device. The following function channels are available:
Batt, Mess, Alrm, Diff, Max, Min, M(t), n(t), M(n), Flow, Time
They cannot be used when connected directly to the PC. The note '!unusable' then
appears in the comment.
- 14 –
Advertisement
Table of Contents
