Table of Contents
Advertisement
5 How to run a Measurement with the
Measuring Module
While connecting the measuring module, please pay attention to the
measuring range indicated on the type plate.
If you want to use the socket adapter as an aid for measuring voltage,
current and power on circuits that are electrically connected directly to
the low-voltage mains, pay attention to the instructions in chapter 6
´Using the socket adapter`.
The measuring module features an ALMEMO
measuring range as well as the dimension are predefined.
Consequently, the measuring module will automatically be recognized
by every ALMEMO
to carry out any additional programming.
5.1 How to measure Voltage DC with the
Module ZED7 00-ABx
Cable the system (especially for measuring voltages greater than 50V)
in power-off state. Only switch on the voltage after the cabling has
been set up completely.
To avoid electric shocks, do not touch any exposed parts or
connections during operation.
Use the supplied touch proof connector cables.
1. Switch off the voltage at the voltage source and check that no voltages are
present.
2. Connect the ALMEMO
socket of the ALMEMO
3. Switch on the ALMEMO
®
V7 measuring device. It is therefore not necessary
plug of the measuring module to an ALMEMO
®
measuring device.
®
measuring device.
®
D7 plug, on which the
®
input
®
- 15 –
Advertisement
Table of Contents
