How To Measure With The Measuring Module; How To Measure Voltage Dc With The Module Zad 900-Abx - Ahlborn ALMEMO ZAD 900-AB Series Instruction Manual

5 How to measure with the measuring
module
Pay attention to the measuring range indicated on the nameplate
when connecting the measuring module.
In case you want to use the adaptor plug as an assistive device for
measuring voltage and current on power circuits that are directly
connected to the low-voltage circuit, pay attention to the Notices in
chapter 6 How to use the adaptor plug.
The measuring module features an ALMEMO
measuring range and the dimension are pre-programmed. As a
consequence, the measuring module will be automatically recognized
by every ALMEMO
before the device can be used.
5.1 How to measure voltage DC with the module ZAD
900-ABx
Wire in a zero potential condition (especially for measurements above
50V). Switch on the voltage afterwards.
During operation never touch any exposed connections and
components to avoid electric shocks.
Use the supplied touch protected connection cables.
1. Switch off the voltage on the voltage source and then check that no voltage
is applied to the module.
2. Insert the ALMEMO
socket of the ALMEMO
3. Switch the ALMEMO
4. Connect the voltage source by means of the connection cables to the
sockets of the measuring module. In doing so, make sure that the red
connection cable is connected to the positive pole and the red socket.
5. Switch on the voltage on the voltage source.
- 14 –
® measuring device. No programming is necessary
plug of the measuring module into an ALMEMO
®
® measuring device.
measuring device on.
®
D6 plug, on which the
®
input
®