Henny Penny FlexFusion FSE-610 Installation Manual page 8

Safety information
2
Setup
Electrical connection
Commissioning
8
▪ Prior to starting the installation work, discuss how to behave in an
emergency.
▪ Use equipment and protective gear suitable for the activity.
▪ Brace housing components to prevent them from falling over and
dropping.
Risk of property damage and personal injury from improper
setup
▪ Where safety shoes and protective gloves.
Risk of fire from improper connection
▪ Observe applicable regional regulations of the electrical utility.
▪ Ensure that only licensed electricians connect the unit.
▪ Ensure that the electrical system is earthed by a protective earthing
conductor.
▪ Note the information on the nameplate.
Risk of electric shock from live components.
▪ Prior to working on the electrical system, switch off the unit, disconnect
the electrical system from the mains and prevent power from being
switched on again. Check to ensure absence of voltage.
▪ Use only insulated tools.
Risk of property damage and personal injury from improper
commissioning
▪ Read the operating instructions prior to commissioning. Observe the
safety instructions in this installation manual and in the "Safety
information" chapter of the operating instructions.
▪ Put the unit into service only after a successful function test following
assembly.
▪ Put the unit into service only after it has reached room temperature.
▪ Observe the units during operation.