Rockwell Automation MultiSight 48MS-SE1PF1-M2 User Manual page 16

MultiSight™ User Manual
Network Settings
Creating a Functioning Ethernet Connection Between a PC and a MultiSight
1. Direct connection (see "Electrical Installation" on page 8)
Network: Start/Settings/Network connections
No red X on Local Area Connection
Set IP address of PC to fixed address
Start/settings/network connections/
(right click) local area connection/
Internet Protocol (TCP/IP)/Properties/
IP address = 192.168.100.101/255.255.255.0
Click Connect/Find in MultiSight PC Software
IP Address area of sensor and PC identical?
Click Connect/Find in MultiSight PC software
and make connection with "Connect"
2. Network connection (see "Network Connection (a) for standard models" on page 10)
16
All cables correctly connected?
24V DC Power Supply?
yes
Electrical connection ok?
MultiSight Pwr LED on
yes
Contact system administrator
Sensor is listed with IP
Success
i.e., IP aaa.bbb.ccc = identical
yes
Success
Done
no
no
Check settings, adjust if necessary
Confirm (via LAN properties) that firewall
wireless networks, and check point
Failure
Start/run/cmd: input. "ipconfig
i.e., aaa.bbb.ccc. = identical to PC IP
no
Start/run/cmd/ping "IP-Adr.Sensor"
Failure
Check software and sensor version?
10000000877(02)
Connect all cables correctly
1. Power and I/O cable
2. Ethernet crossover cable
secure remote are disabled.
After second attempt
Execute "Ipconfig
Execute "ARP"
Start/run/arp -a -d
Reset IP address of sensor
address area
.ddd = differen
Execute "Ping"
e.g., "192.168.100.100"