Ethernet - Phoenix Contact ILC 330 User Manual

6959_en_05
2.12.1

Ethernet

A standardized Ethernet interface is available for connecting the Ethernet network. The
Ethernet network is connected via an RJ45 female connector.
Use an Ethernet cable according to CAT5 of IEEE 802.3.
Planning and installation of your Ethernet network must be carried out according to the
IAONA "Industrial Ethernet Planning and Installation Guide" (see Internet at
www.iaona-eu.com).
The pin assignment of the interface is as follows:
Figure 2-17 Ethernet interface
Figure 2-18 Connecting the Ethernet cable to the Inline Controller
A crossover twisted-pair cable is required for direct connection of the Inline Controller to
another Inline Controller or to a PC.
Description of the Inline Controller
PHOENIX CONTACT
2-21