Preface; Purpose Of This Manual; Hardware And Software Requirements - Phoenix Contact ILC 330 User Manual

1

Preface

ILC 330 ETH
ILC 350 ETH
ILC 350 ETH/M
ILC 350 PN
6959_en_05
1.1

Purpose of this Manual

This manual helps you to start up and operate the ILC 330 ETH, ILC 350 ETH,
ILC 350 ETH/M or ILC 350 PN Inline Controller.
1.2

Hardware and Software Requirements

– Inline Controller
– 32 MB or 64 MB parameterization memory
– Connecting cable for connecting the Inline Controller to a PC (RS-232)
– PC WorX automation software in the following versions:
PC WorX version 5.10 or later Service Pack 1
(Part of the AUTOMATIONWORX Software Suite 2007 1.30 Service Pack 1)
PC WorX version 3.03 or later
When using PC WorX 3.03 it is necessary to upgrade the data for the ILC 350 ETH from
the "Upgrade ILC 350 ETH" CD. The CD is supplied with the Inline Controller.
Upgrading is not required in later versions.
PC WorX version 3.12 or later Service Pack 1
(Part of the AUTOMATIONWORX Software Suite 2005 1.10)
PC WorX version 5.00 or later
(Part of the AUTOMATIONWORX Software Suite 2006 1.20)
For the ordering data for hardware and software and additional documentation, please
refer to Section "Technical Data and Ordering Data" on page 5-1.
Preface
1-1
PHOENIX CONTACT