Table of Contents
Advertisement
UM EN ILC 330/350
Table 4-10
System variables of the power supplies
System Variable
POWER_SUPPLY_MAIN_OK
POWER_SUPPLY_INPUTS_OK
POWER_SUPPLY_OUTPUTS_0_3_OK
Table 4-11
System variables of the Ethernet status (firmware version 4.6F/1.11 or later)
System Variable
ETH_PORT1_LINK
ETH_PORT1_100MBIT
ETH_PORT1_FULL_DUPLEX
ETH_PORT2_LINK
ETH_PORT2_100MBIT
ETH_PORT2_FULL_DUPLEX
ETH_SRV_FTP_ACTIV
Table 4-12
System variables of the mode selector switch
System Variable
KEY_SWITCH_RESET
KEY_SWITCH_STOP
KEY_SWITCH_RUN
KEY_SWITCH_RUN_PROG
4-8
PHOENIX CONTACT
4.1.10
Power Supplies
Type
BOOL
BOOL
BOOL
4.1.11
Ethernet Status
Type
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
4.1.12
Mode Selector Switch
Type
BOOL
BOOL
BOOL
BOOL
Meaning
The 24 V main power supply is OK.
The 24 V power supply for the local inputs is OK.
The 24 V power supply for the local outputs is OK. (Bits 0 to 3)
Meaning
The external Ethernet port is connected.
The baud rate of the external Ethernet port is 100 Mbps.
A full duplex connection is connected to the external Ethernet
port.
The internal Ethernet port is connected.
The baud rate of the internal Ethernet port is 100 Mbps.
A full duplex connection is connected to the internal Ethernet
port.
The Ethernet FTP service is activated.
Meaning
The mode selector switch is in the MRESET position.
The mode selector switch is in the STOP position.
The mode selector switch is in the RUN position (not supported
in the first version of the ILC 350 ETH).
The mode selector switch is in the RUN_PROG position.
6959_en_05
Advertisement
Table of Contents
