For the installer
f Remove cover on motor – Fig. 118.
f Mount the motor with 1x M8x16 screw at the top first (the screw is pre-assembled on the storage container), followed
by 4x M10x25 screws and M10 nuts at the bottom – Fig. 119.
Fig. 118
f Push both seals onto flange plates correctly. Screw the storage container to the holder using 8x M8 flange nuts –
Fig. 120.
f Adjust the set screws – Fig. 121.
8x
M8
Fig. 120
f Lay the cable for the motor and the cable for the proximity sensor, connect them, and secure with cable ties –
Fig. 122, Fig. 123.
Fig. 122
4x
M10 M10 x 25
Fig. 119
Fig. 121
Fig. 123
43
1x
M8 x 16