Windhager PUROWIN PWPE 60 Installation Instructions Manual page 16

For the installer
a) Using iron rods to roll it off by hand
CAUTION Material losses
Before removing the base pallet, screw in all 4 adjustable feet on the bottom of the boiler; otherwise, there
is a risk of causing damage – Fig. 8.
f To make it easier to remove the pallet, slide some iron rods with a diameter of between 25 and 30 mm under the
boiler (Fig. 9, Fig. 10). Then roll the boiler off the pallet and pull the pallet away – Fig. 11.
Fig. 8 Screwing in all 4 adjustable feet on the bottom of the boiler
Fig. 10 Sliding the boiler o the pallet
b) Sawing through the crate with a hand-held power saw
f Remove the wooden crate surrounding the boiler, e.g. by sawing through it with a power saw.
f Tilt the boiler backwards on the base pallet. Then saw through the two front slats at the sides – Fig. 12
f Tilt the boiler forwards and remove the remains of the base pallet – Fig. 13.
Fig. 12 Tilting the boiler backwards and sawing through and removing
the front slats
Fig. 9 Placing an iron rod under the boiler
Fig. 11 Rolling the boiler o the pallet
Fig. 13 Tilting the boiler forwards and removing the remains of the
base pallet
16