Connecting Multiple Inverters Through Rs485 - SolarEdge Energy Bank Installation Manual

Home hub inverter single phase for australia

Hide thumbs Also See for Energy Bank:

Table of Contents

2. Insert the battery into the battery holder in the Connection Unit.

3. Close the Connection Unit covers with the Allen screws.

Connecting Multiple Inverters through RS485

Before connecting multiple inverters, make sure your inverters' firmware version

supports this feature. For further information, contact SolarEdge support.

You can add inverters to your system to increase on-grid and backup power

production. Up to two additional SolarEdge Home Wave Inverter - Single Phase or

SolarEdge Home Hub Inverter Single Phases may be connected to a single SolarEdge

Home Hub Inverter Single Phase.

If a battery and Backup Interface are installed, the AC output from the additional

inverters must be connected to the Backup Interface. Use a circuit breaker (CB-UPG-xx-

01) purchasable from SolarEdge. For more information, refer to the Backup Interface

Installation Guide .

When connecting multiple inverters, use the following cable types:

Communication - 0.25 mm

To connect an additional SolarEdge Home Hub Inverter Single Phase:

1. Connect the Leader inverter to the Backup Interface, as explained in Connecting the

Backup Interface on page 36.

2. In both inverters, pass the communication cable through Communication Gland 2.

SolarEdge Home Hub Inverter Single Phase MAN-01-00812-1.5

Figure 16: Installing the 9V Battery

(0.25–1.5 mm

), 600V insulated or CAT6

Chapter 5: Connecting the

Inverter 41

Table of Contents