Enabling Demand Response Mode For Zero Export - SolarEdge Energy Bank Installation Manual

The Backup application can be used whether or not PV modules are installed at the site.
The backup function is disabled by default and can be enabled for on- grid only
application, if backup is not needed.
To start using StorEdge applications, you first need to enable the Backup Configuration
functionality (disabled by default). If Backup Configuration is disabled, the system will
use the battery energy in the following cases:
When PV production is not sufficient in MSC
When using one of charge/discharge profiles that requires battery discharge
However stored energy will not be used to back up the loads in case of power outage.
To enable Backup Configuration:
Open SetApp and select Commissioning > Power Control > Energy Manager >
Backup Configuration > Backup > Enable.
After the Backup Configuration is enabled, the Backup Interface is automatically
configured.
To enable a StorEdge application:
1. Select Power Control > Energy Manager > Energy Control.
2. Select one of the following applications:
Backup only - Set the system to supply power to backed-up loads only in case of
a power outage.
Time of use - Set a charge/discharge profile and the level of charging the battery
from AC.
Maximum Self Consumption (MSC) - Set the system to maximize self-
consumption, and then the level of stored energy to be reserved for backup.

Enabling Demand Response Mode for Zero Export

1. Access SetApp.
2. From the Commissioning screen, select Power Control > Power Reduction
Interface (RRCR) Mode > DRM.
For more information on zero export and demand response enabling devices (DRED),
see:
https://www.solaredge.com/sites/default/files/dred-connection-application-note.pdf
SolarEdge Home Hub Inverter Single Phase MAN-01-00812-1.5
Chapter 6: Activating, Commissioning and Configuring the System 49