SolarEdge Energy Bank Installation Manual page 52

Creating Logical and Physical Layout using Installation
Information
To display a logical layout, insert the inverter serial number in the new site created in
the monitoring platform. When the communication between the inverter and the
monitoring server is established, the logical layout is displayed.
To display a physical layout, you need to map the locations of the installed power
optimisers. To map the locations, use one of the methods described in the next sections.
Designer
Designer recommends inverter and Power Optimiser selection per site size and enables
report generation. You can create a project in Designer and export the site design with
the PV array layout to the monitoring platform.
For more information, refer to
tools/designer#/.
Mapper Application
Use the Mapper smart phone application to scan the Power Optimiser and inverter 2D
barcodes and create a virtual map of a PV site for enhanced monitoring and easier
maintenance.
The Mapper
Simple on-site registration of new systems.
Creating, editing and verifying system physical layout.
Scanning and assigning the Power Optimiser serial number to the correct module
in the system physical layout.
For detailed information, refer to the Mapper demo movies:
Creating new sites using the Mapper mobile application
Mapping existing sites using the Mapper mobile application
Physical Layout Editor
1. If you are a registered installer, access the monitoring platform site creation page at
https://monitoring.solaredge.com/solaredge-web/p/home#createSites. If you have
not yet signed up, go to
web/p/createSelfNewInstaller.
SolarEdge Home Hub Inverter Single Phase MAN-01-00812-1.5
Chapter 6: Activating, Commissioning and Configuring the
https://www.solaredge.com/products/installer-
https://monitoring.solaredge.com/solaredge-
System 51