SolarEdge Energy Bank Installation Manual page 40

Home hub inverter single phase for australia
Hide thumbs Also See for Energy Bank:
Table of Contents

Advertisement

To connect an external RSD switch to a single inverter
 1. Remove the factory installed RSD- wire that connects between the 7-pin Backup
Interface connector and the Safety Switch.
Do not disconnect the RSD+ wire.
 2. Pass the wires from the external RSD switch through Communication Gland 2.
 3. Connect the positive wire to the Safety Switch and the negative wire to the RSD-
port on the Backup Interface connector.
To connect an external RSD switch to multiple inverters:
 1. Connect the external RSD switch to the Leader inverter, as explained above.
SolarEdge Home Hub Inverter Single Phase MAN-01-00812-1.5
Chapter 5: Connecting the
Inverter   39

Advertisement

Table of Contents
loading

Table of Contents