Setting The Awt-3; Preparation For A Walk Test - Optex REDWALL-V Adjustment Procedures Manual

1. Remove the AVF-1 from the unit, and then
put the plug of AWT-3 into the unit.
AVF-1
2. Confirm that CONNECTION SELECT
SWITCH is at REDWALL-V.
3. MODE SELECT SWITCH is used for
Far, Near and Creep zone detection.
Change all sensitivity switch to "SH",
and confirm if the position of logic
selector is "OR".
Step6. Setting the AWT-3
Step7. Preparation for walk test
3
2
Dark gray
area
Page 7/18
AWT-3