Overview - cytiva Sepax C-Pro Operating Instructions Manual

5.6.1

Overview

The table below provides an overview on how to run a procedure. See the Operator
Manual of the application for more information about a specific application workflow,
parameters, kit installation, and troubleshooting.
Phase Description
1 Select the application.
2 Edit the parameter values (if applicable).
3 Configure the traceability IDs (if applicable).
4 Verify the kit and packaging, before opening the kit
blister pack (e.g., integrity of the package, sterilization
indicator and expiration date).
5 Open the kit blister pack , connect required bags (e.g.,
initial bag) and attach traceability labels, if applicable.
6 Install single-use kit components on the instrument.
7 Start the procedure.
8 Edit the traceability ID values.
9 Monitor the procedure by following the on-screen
prompts during the automatic procedure.
10 Finish the procedure by following the on-screen prompts
at the end of the procedure.
11 Remove the single-use kit from the instrument.
12 Disposal of the single-use kit according to the user inter-
nally validated Standard Operating Procedures (SOP)
and local regulations.
Sepax C-Pro Operating Instructions 29350570 AE OM-3074
5 Operation GMAP 5.5
5.6 Running a procedure
5.6.1 Overview
Instructions
See Section 5.6.2 Select an
application, on page 94.
See Edit a parameter, on
page 95.
See Configure the tracea-
bility ID, on page 99.
See the application Oper-
ator Manual.
See the application Oper-
ator Manual.
See the application Oper-
ator Manual.
See the application Oper-
ator Manual.
See Edit the traceability
IDs, on page 100.
See the application Oper-
ator Manual.
See the application Oper-
ator Manual.
See the application Oper-
ator Manual.
See the application Oper-
ator Manual.
93