Lpr Port Printing Using Tcp/Ip In Windows 95 / Windows; Windows Me - Panasonic WORKIO DP-CL21 Network Manual

Settings and Printing

LPR Port Printing using TCP/IP in Windows 95 / Windows 98

/ Windows Me

The following are the steps to set up an LPR Port printing using TCP/IP in Windows 95 / Windows 98 /
Windows Me.
Step 1: Setting up TCP/IP on the computer
Step 2: Setting up TCP/IP on the printer
Step 3: Setting up the printer driver and the printer port on the computer
• When printing directly from a computer to the printer, perform this step on each computer
(Windows 95, Windows 98 or Windows Me).
• When printing through a shared computer (server), perform steps 3 and 4 on the server computer
(Windows 95, Windows 98 or Windows Me), then perform step 5 on each client computer
(Windows 95, Windows 98, Windows Me, Windows NT 4.0, Windows 2000 or Windows XP).
Step 4: Sharing the printer port on the server computer
Step 5: Setting up the printer driver and the printer port on the client computer
■ Step 1: Setting up TCP/IP on the computer
If the TCP/IP protocol is already installed on your computer and it is configured, proceed to the next
step. If it is not installed, you need to install TCP/IP in the operating system on the computer and
configure it. Be sure to install the TCP/IP protocol as it is not installed by default in Windows 95.
If the administrator manages the IP Address, contact him/her to confirm the values before setting up.
Be sure to assign the unique value for the IP Address that is not used on another device on the
network. Refer to the example of
Address is set correctly, see
Checking the configuration of TCP/IP, refer to the help menu or documentation for Windows.
Maintenance and Spec.
"Using the Network Setup Tool" on page
page 15.
Network
Network
Setup in Windows
11. To confirm that the IP
9