Panasonic WORKIO DP-CL21 Network Manual page 11

Settings and Printing
■ Using the Network Setup Tool
If the administrator manages the IP Address, contact him/her to confirm the values before the
installation. If not, set the unique value that is not used by another device on the network. Refer to the
example shown below.
Example (assigning the IP Address, Subnet Mask and Default Gateway)
IP Address:
Subnet Mask:
Default Gateway:
NOTE:
• 0 should not be used at the initial value of IP Address. For example, if the IP Address is 5, enter the
number 5 (05 or 005 is incorrect). If there are any 0's, 0 is OK, but 00 or 000 is incorrect.
First install the Network Setup Tool by using the printer CD-ROM disk and then set up TCP/IP on the
printer.
If the Network Setup Tool is already installed, click [Start] , move the pointer to Programs or All
Programs, Panasonic and Panasonic DP-CL21P or Panasonic DP-CL21M, then click Network
Setup Tool.
Proceed to the step 6.
1
Insert the printer CD-ROM disk into the CD-ROM drive.
The CD-ROM launches automatically.
NOTE:
• If the CD-ROM does not launch automatically, perform the following steps.
(1) Double click My computer icon (Windows XP: start - My Computer).
(2) Double click the CD-ROM icon.
Maintenance and Spec.
172.16.x.x
(x: you can choose any number from 0-255 except 0.0 and 255.255)
Be sure that the IP Address is not assigned to the other devices.
255.255.0.0
It is the same value for all devices.
Not required. (0.0.0.0 or set to same as other devices on the network)
Network
Network
Setup in Windows
11