JUMO LOGOSCREEN 500 Operating Instructions Manual page 53

Memory alarm Configuration
➔ Instrument data
(diskette
reserve)
Code number Configuration
➔ Instrument data
of configuration
Code number Configuration
➔ Instrument data
of disk manager
(Disk Code No.)
Code number Configuration
➔ Instrument data
Counter/Int. reset
Code number Configuration
➔ Instrument data
RS232/RS485
Factory setting Configuration
➔ Instrument data
Enable options Configuration
➔ Instrument data
Enable options Configuration
➔ Instrument data
Code No.
determined
All manuals and user guides at all-guides.com
➔ Memory alarm
➔ Code No. (password)
➔ Configuration
➔ Code No. (password)
➔ Disk manager
➔ Code No. (password)
➔ Counter/Int. reset
➔ Code No. (password)
➔ RS232/RS485
➔ Enter defaults
➔ Enable options
➔ Enable options
➔ Code No.
determined
4 Configuration parameters
1 — 10 — 100%
0000 — 9200 — 9999
0000 — 9200 — 9999
0000 — 9200 — 9999
0000 — 9999
No, Yes
(display of Code No.)
The signal is activated
when the residual capacity
of the diskette, or of the
internal memory, has
fallen to this value.
The parameter Memory
readout can be used to
determine whether the
alarm was initiated by the
diskette or the memory.
v Chapter 2.4 "Event tra-
ces"
Code number for
configuration level;
0000 = off
The data saved on dis-
kette and in the FLASH
memory are deleted
when the configuration is
changed.
Code number for
functions in the
"File manager" menu;
0000 = off
Code number to delete the
individual counts;
0000 = off
Code number to protect
from unauthorized access
to data via the serial
interface;
0000 = off
Yes = enter factory default
setting (when entered, the
parameter returns
automatically to No)
The parameter is available
for enabling additional
functions, such as the
math/logic module or
counter/integrator. The
parameter is not available
if all recorder functions
have been enabled.
The manufacturer has to
be informed about the
value displayed here and
will issue the enabling
code.
51