Table of Contents
Advertisement
Positioning
After pressing the key, the following dialog is available for positioning the cur-
the cursor
sor on a specific time:
After the date and time have been entered and the
pressed, the cursor is positioned on the selected time.
If no measurement data have been stored for the selected time, then the cur-
sor is positioned on the next possible time.
Peak value
If the data have been recorded in the "peak value" mode, then two different
acquisition
measurements (one minimum and one maximum value) may be displayed
graphically for one instant of time (storage rate). Using the
is possible to switch between minimum and maximum value display within the
display mode "measurement".
Minimum
Maximum
Peak value acquisition is programmed (activated) by the parameters:
- Configuration ➔ Measurement storage ➔ Normal display ➔ Stored value
- Configuration ➔ Measurement storage ➔ Event operation ➔ Stored value
- Configuration ➔ Measurement storage ➔ Timed operation ➔ Stored value
Further information on the "Measurement" display mode can be taken from
Chapter 3.2.1 "Diagram representation with digital display (small measure-
ment)" and Chapter 3.2.4 "Large digital display (large measurement)".
All manuals and user guides at all-guides.com
3 Operation and visualization
Function key
key has been
key, it
Channel line
31
Advertisement
Table of Contents
