Table of Contents
Advertisement
3 Operation and visualization
Status
Status messages of the disk manager are displayed in the corresponding ac-
messages
tion window. The following status messages are possible:
Status message
DISKETTE UPDATED
DISKETTE NOT UPDATED
INITIALIZING DISKETTE
NO DISKETTE
DISKETTE
WRITEPROTECTED
DISKETTE FAULTY
DISKETTE FULL
PROGRAM DISKETTE
CONFIG. DISKETTE
40
All manuals and user guides at all-guides.com
Description
Directly before removing the diskette from the
instrument, it is necessary to call up Update
diskette, so that all the measurement data up to
the time of removal are contained on the diskette.
The data not yet saved since the last automatic
save are written to diskette.
An error has occurred during updating.
This message may have several causes.
Remedy:
Repeat procedure
The instrument recognizes when new or foreign
diskettes are inserted.
A
New or foreign diskettes are
overwritten without a security check.
If there is no diskette in the instrument, the
diskette symbol flashes in the status line.
The inserted diskette cannot be written to
because it is write protected.
Remedy:
Remove write protection.
An error has occured while writing to diskette.
The diskette is faulty.
Remedy:
Insert new (DOS-formatted) diskette.
If the diskette is full, the diskette symbol flashes in
the status line. No more data are written to
diskette.
Remedy:
Insert a blank diskette before the measurement
data memory of the recorder is also full. If this is
not done, then measurement data will be lost.
This message appears when a program diskette is
inserted in the disk drive and measurement data
have to be written.
Remedy:
Insert the correct diskette, or a blank one.
This message appears when a configuration dis-
kette is inserted in the disk drive and measure-
ment data have to be written.
Remedy:
Insert the correct diskette, or a blank one.
Advertisement
Table of Contents
