Table of Contents
Advertisement
Installation
Mounting
______________________________________________________________________________
Installation
The small footprint of the MillipaK controller gives maximum flexibility to the user for mounting
options. The following section gives details of certain criteria that should be considered when
situating the controller on a vehicle.
Mounting
The MillipaK HP unit provides 4 x M6 clearance holes for mounting. The controller should be
mounted onto a metal base plate, as large as possible to provide heat-sinking. The surface finish
should be flat, clean and burr free and thermal compound should be applied to the controller base
before fitting.
Figure 1: MillipaK HP Dimensions
Maximum terminal torque:
M8 terminals – 10NM
M6 terminals – 7NM
MillipaK 4QPM Controller Manual
Page 7
13/08/03
Advertisement
Table of Contents
