Status And Test Information - Sevcon MillipaK 4QPM Manual

Calibrator
______________________________________________________________________________

Status and Test Information

Menus 13 to 19 are primarily used for providing information about the system. Every parameter
which the system measures in located in one of these menus. A brief description of the purpose of
each menu is listed below.
Menu Name
13 System Status
14
15 System Voltages
16 Motor Voltages
17 Motor Currents
Heatsink
18
Temperature
19 Test Menu
Table 3: Status and Test Information Menus
MillipaK 4QPM Controller Manual
If there is a fault active in the system, this menu provides
information about what the fault is. Refer to the Diagnostics
section for more information.
- Reserved for future use.
Used to display Battery and Capacitor Voltage measurements.
The Battery Voltage measurement shows the voltage measured
at the Keyswitch pin (pin 1 on connector B). The Capacitor
Voltage measurement shows the voltage measured at the B+
terminal.
Used to show the voltage measured at the Point A terminals.
Used to show the Armature Current Measurement.
Used to access the Heatsink Temperature measurement. Refer to
the Temperature Monitoring section.
Used to access items which allow for testing of all the Analogue
and Digital inputs available on connector B. Also displays unit
information such as the Software Version, Controller Serial
Number and the Personality Checksum. Refer to the appropriate
sections for more information on each of these items.
Calibrator/Status and Test Information
Purpose
Page 16 13/08/03