Adjustments - Sevcon MillipaK 4QPM Manual

Calibrator
______________________________________________________________________________

Adjustments

Menus 0 to 12 are primarily used for configuring the system. All the personalities that the system
uses to configure each function are in one of these menus. A brief description of the purpose of
each menu is listed below. For more complete descriptions of each personality refer to the
appropriate section in this manual.
Menu Name
0 Current Limits
1 Braking Levels
2 Accelerator
3 Creep Speed
4 Bypass
5 Maximum Speed
6 Cutback 1 Speed
7 Cutback 2 Speed
8 Motor Setup
9 Power Steer Timer
10 Seat Delay
Additional
11
Personalities
12 System Setup
Table 2: Adjustment Menus
MillipaK 4QPM Controller Manual
Used to setup maximum currents for motor.
Used to setup braking strength and performance.
Used to setup acceleration and deceleration performance and to
configure the accelerator input voltage range.
Used to setup creep speed.
Not Used
Used to setup maximum speeds.
Used to setup the speed for Cutback Speed 1.
Used to setup the speed for Cutback Speed 2.
Used to setup motor protection levels.
Used to setup the Power Steer timer.
Used to setup the Seat Switch debounce delay.
Used to setup additional personalities. These are personalities
which do not belong in any of the menus shown above, or they
are deemed to be unsuitable for modification by service
engineers or end users.
Used to configure the system at a high level. Items to configure
the system I/O and performance are located in here. It is
recommended that items in this menu are configured first before
any of the other personalities. Unlike the personalities in the
other menus, changes to items in this menu do not take affect
until the Keyswitch is recycled.
Page 15
Calibrator/Adjustments
Purpose
13/08/03