Senlan Hope800 Series Manual page 72

6 Parameter Description
to raise the comfort degree in elevators, prevent the falling of objects on conveyors, or reduce the impact
to equipment at the start/stop.
The total accel/decel time is extended after the S-curve accel/decel time is set, as shown below.
Frequency
Accel start
stage
The calculation formula for the total accel/decel time is:
Total accel/decel time=accel/decel time for non S-curve+
If the total accel/decel time obtained from the above formula is less than the sum of accel/decel start-stage
time and accel/decel end-stage time, then:
Total accel/decel time= accel/decel start-stage time +accel/decel end-stage time
The S-curve function becomes invalid if F1-17 doesn't equal zero.
F1-36
Setting
0.0~3600.0s
range
Deadband time is the waiting time during which the motor switches from forward run to reverse run or
vice virsa. It is used to reduce the impact to equipment during the forward-reverse switching.
F1-37
Setting
0.10~50.00Hz
range
F1-38
F1-39
0.1~60.0s
Setting
Note: The factory setting of jog accel/decel time is 6.0s for models of 22 kW or less, and
range
20.0s for 30kW or above
 In keypad control mode, if the thousands digit of FC-01 is set to 1, then pressing the key
the jog operation, while in terminal control mode the digital input 14 or 15 may activate the jog
operation. If both digital inputs are valid or invalid, jog operation will become invalid.
In jog operation, the functions of "auxiliary reference" and "PID frequency correction" are invalid.
The start/stop mode for jog operation is fixated to "starts from starting frequency" and "slowdown stop".
68
Linear
Accel end
accel stage
stage
Total accel time
(accel/decel start-stage time＋accel/decel end-stage time)÷2
Deadband time
Jog frequency
Jog accel time
Jog decel time
Stable Decel start
Linear
run stage stage
decel stage
Total decel time
Default
Default
Default
Default
Time
Decel end
stage
0.0s Change
5.00Hz Change
Depends
Change
on model
Depends
Change
on model
will activate
×
○
○
○