Senlan Hope800 Series Manual page 52

5 Parameter table
No. Name
underload protection
Fb-08
detection time
Analog input
Fb-09
disconnection action
Frequency after analog
Fb-10
input disconnection
Fb-11 Other protection actions
Accel overcurrent
Fb-12
stall prevention
Accel overcurrent stall
Fb-13
point
Constant-speed
Fb-14 overcurrent stall
prevention
Constant-speed
Fb-15
overcurrent stall point
Overvoltage stall
Fb-16
prevention
Fb-17 Overvoltage stall point
DC link undervoltage
Fb-18
action
48
Setting range
0.0~100.0s
0: No action
1: Run at the average frequency within 10s
before disconnection, with an AL.Aco alarm
2: Run at the frequency set by Fb-10, with
an AL.Aco alarm
3: Coast to a stop, with an Er.Aco alarm
0.00Hz~F0-06
Units digit: inverter input phase loss
protection
0: No action
1: Continue running with an alarm
2: Coast to a stop due to fault
Tens digit: inverter output phase loss
protection
0: No action
1: Continue running with an alarm
2: Coast to a stop due to fault
Hundreds digit:
protection
0: No action
1: Continue running with an alarm
2: Coast to a stop due to fault
Thousands digit: parameter store failure
protection
0: Continue running with an alarm
1: Coast to a stop due to fault
0: Invalid
10.0~150.0％(inverter rated current=100%)
0: Invalid
10.0~150.0％(inverter rated current=100%)
0: Invalid
650~750V, default 700V
0: Coast to a stop and report the
undervoltage fault(Er.dcL)
1: Coast to a stop, and restart if the voltage
resumes within the time set by Fb-20 or report
the undervoltage fault(Er.dcL) if undervoltage
time exceeds the time set by Fb-20
2: Coast to a stop, and restart if CPU is still
working and detects that the voltage resumes,
without reporting the undervoltage fault
keypad disconnection
1: Valid
1: Valid
1: Valid
Default Change Page
×
1.0s 110
×
0 110
○
0.00Hz 110
×
0022 111
×
1 111
×
111
150.0％
×
1 111
×
111
150.0％
×
1 111
×
700V 111
×
0 112