Senlan Hope800 Series Manual page 32

4 Operation and commissioning
Monitoring
status
To next level menu
monitoring status
Display onitored
parameters cyclically
Monitoring status in standby state
Pressing
FC-02~FC-08).
Monitoring status in run state
Pressing in this status cyclically displays the run-state parameters (defined by FC-02~FC-12).
Parameter editing status
In monitoring status, pressing
parameter group number→serial number in parameter group→parameter value. Pressing
next menu and pressing
menu). Pressing
group or parameter values. Under the third level menu, the digit which can be edited blinks. Pressing
switches the digit to be edited to another digit, and pressing
second level menu, and the next parameter is displayed.
When FC-00=1(only user parameters are displayed) or 2(only parameters different from default values are
displayed), the first level menu doesn't appear, so that the user operation can be faster.
Password check status
If there is a user password(F0-15 not equal to zero), before you can edit any parameter you enter the
password check status and "――――" is displayed. Input the password with
("――――" is displayed during input) and press
this moment, press
check status.
In the monitoring status following the right password is input, if
no any keystroke within two minutes, the password protection will take effect automatically.
28
1st-level
menu
Back to
To previous level menu
Change menu number
in this status cyclically displays the standby-state parameters (defined by
enters the editing status, which contains three level menus:
returns to the previous menu (returns to monitoring status if at the first level
and change the parameter group numbers, serial numbers in parameter
returning to the password check status and press
2nd-level
menu
To next level menu
Change parameter number
Select digit
to be modified
saves the modified data and returns to the
. If the password is not correct, "Err" blinks. At
3rd-level
menu
To next level menu
To previous level menu
Increase/decrease
parameter value
Save parameter
,
again exiting the password
＋
are pressed or there is
Select digit
to be modified
enters the
and