Senlan Hope800 Series Manual page 66

6 Parameter Description
Digital input 42 can compulsively switch the command source (see page 76 for details).
F0-03
Units digit:
the frequency saving
mode
failure.
Setting
range
Tens digit:
the
holding mode in stop
state.
This parameter is valid only when F0-01=0 or 1.
F0-04
Seting 0: None
range 6: Arithmetic unit 1 7: Arithmetic unit 2 8: Arithmetic unit 3
F0-05
Setting
-1.000~1.000
range
Refer to F0-00 and F0-01.
F0-06
Setting V/F control: F0-07~650.00Hz
range Vector control: F0-07~200.00Hz
F0-07
Setting
F0-08~F0-06
range
F0-08
Setting
0.00Hz~F0-07
range
F0-06 is the frequency corresponding to 100% of the frequency setting.
F0-07 and F0-08 limit the size of the reference frequency.
F0-09
Setting
0: Forward or reverse
range
It is recommended to set F0-09 to 1 or 2 when only a single direction is required.
If you want to change the direction via the key
F0-10
0: All parameters can be changed except read-only ones
Setting
1: All parameters can't be changed except F0-00, F7-04 and F0-10
range
2: All parameters can't be changed except F0-10
F0-10 is used to prevent parameters from being modified unexpectedly.
F0-11
62
Frequency holding
selects
0: Frequency changed via
F0-00.
after power
1:
stored.
selects
0: Frequency changed via
frequency
1: Frequency changed via
to F0-00.
Auxiliary reference channel
1: F0-00 2: UP/DOWN value
Auxiliary reference gain
Max. frequency
Upper-limit frequency
Lower-limit frequency
Direction lock
Parameter protection
Parameter initialization
Default
Frequency changed via
Default
3: AI1
Default
Default
Default
Default
Default
1: Forward only
, you should set the hundreds digit of FC-01 to 1 or 2.
Default
Default
00 Change
, or communication is stored in
, or communication is not
, or communication is retained.
, or communication is restored
0 Change
4: AI2
9: Arithmetic unit 4
1.000 Change
50.00Hz Change
50.00Hz Change
0.00Hz Change
0 Change
2: Reverse only
0 Change
00 Change
○
○
5: PFI
○
×
×
×
○
○
×