Removing The Intel ® Rmm3 And Intel ® Rmm3 Nic; Replacing The Backplane Board; Figure 41. Attach The Intel ® Rmm3 Module To Rear Chassis - Intel SR1695WB Service Manual

Removing the Intel
Use the reverse steps to remove the Intel
1. Remove the two screws from rear chassis to loosen Intel
"C").
2. Plug out Intel
3. Install the Intel
"A").

Replacing the Backplane Board

The instructions below describe how to replace the backplane board in the system.
®
Intel Server System SR1695WB Service Guide
A
Figure 41. Attach the Intel
®
RMM3 and Intel
®
RMM3 NIC module cable from the server board (see letter "B").
®
RMM3 NIC module cover into the system back panel (see letter
C
®
RMM3 module to rear chassis
®
RMM3 NIC
®
RMM3 module
B
AF003470
®
RMM3 board (see letter
51