Pppoe - Grundig GU-RN-AC8104P User Manual

If you connect to a router allows to use DHCP, please check the DHCP box. The router will assign
automatically all the network parameters for your NVR. Unless the network is manually addressed
below parameters:
IP Address: The IP address identifies the NVR in the network. It consists of four groups of numbers
between 0 to 255, separated by periods. For example, "192.168.001.100".
Subnet Mask: Subnet mask is a network parameter which defines a range of IP addresses that can be
used in a network. If IP address is like a street where you live then subnet mask is like a
neighborhood. The subnet address also consists of four groups of numbers, separated by periods. For
example, "255.255.000.000".
Gateway: This address allows the NVR to access the Internet. The format of the Gateway address is
the same as the IP Address. For example, "192.168.001.001".
DNS1/DNS2: DNS1 is the primary DNS server and DNS2 is a backup DNS server. Usually, it should be
enough just to enter the DNS1 server address.

5.5.1.2 PPPoE

This is an advanced protocol that allows the NVR to connect to the network more directly via DSL
modem.
Check the "Enable PPPOE" box, and then enter the User name & Password of the PPPoE.
Click Apply to save, system will reboot to active the PPPoE setting.
88 English