Table of Contents
Advertisement
Start Time: Set the detection start time.
End Time: Set the detection end time.
Reset Count: Clear the counting number.
Rule Number: Only 1 rule available.
Rule Switch: Activate or inactivate the rule.
1. Choose the detection target type.
2. Set the Alarm Number, Start Time and End Time.
3. To enable the detection in Rule Switch.
4. Choose a Rule Type.
A→B: If a target object is detected moving from side A to side B, the system will count 1 to enter
number; if a target object is detected moving from side B to side A, the system will count 1 to exit
number.
B→A: If a target object is detected moving from side B to side A, the system will count 1 to enter
number; if a target object is detected moving from side A to side B, the system will count 1 to exit
number.
5. Use your mouse to click 2 points in the camera picture to draw a virtual line.
6. Click Save to save your settings.
7. If you want to modify the position or length of the line, click the red box in the line, the color of
the line will be changed to red color. Click and hold the left button of your mouse to move the line,
or drag the terminals to modify the length or position of the line.
8. If you want to remove one of the lines from the camera picture, click the red box in the line and
then click Remove button. Click Remove All will delete all lines.
5.4.1.6 HM (Heat Map)
Automatically regular detect and count the movement of objects in the monitoring area. The
frequency of people flows will be identified by different colors.
Switch:
Check the box to enable LCD function.
Click Setup icon
to configure the detection conditions.
69 English
Advertisement
Table of Contents
