Table of Contents
Advertisement
4.
Click one of the Setup icons
Switch: Activate or inactivate the detection.
Type: Choose the detection target objects. Motion will detect all moving objects, Person will detect
human beings only, Vehicle will detect vehicles only.
Sensitivity: Set the sensitivity level. Level 1 the lowest sensitivity level while level 4 is the highest
sensitivity level.
Rule Type:
A→B: If a target object is detected moving from side A to side B, the system will count 1 to enter
number; if a target object is detected moving from side B to side A, the system will count 1 to exit
number.
B→A: If a target object is detected moving from side B to side A, the system will count 1 to enter
number; if a target object is detected moving from side A to side B, the system will count 1 to exit
number.
Start Time: Set the detection start time.
End Time: Set the detection end time.
Dynamic Marking：If you enable this option, the border of the detection zone will be displayed in
both live view images and recording files.
Configuration Steps:
i. Activate the Switch.
ii. Choose the detection target type.
iii. To set the Sensitivity.
iv. Choose a Rule Type.
v. Set the Start Time and End Time.
vi. Use your mouse to click 2 points in the camera picture to draw a virtual line.
vii. Click Save to save your settings.
viii. If you want to modify the position or length of the line, click the red box in the line, the
color of the line will be changed to red color. Click and hold the left button of your mouse
to configure the detection conditions.
133 English
Advertisement
Table of Contents
