Mercedes-Benz G-Class Owner's Manual page 415

412 Technical data
Engine oils for one-time filling only in exceptional
cases:
MB-Freigabe or MB-Approval 229.51 or
R
ACEA C3
The following values refer to an oil change,
including the oil filter.
Model
All models
Notes on brake fluid
Observe the notes on operating fluids
( page 405).
/
& WARNING Risk of an accident due to
vapour pockets forming in the brake sys‐
tem
The brake fluid constantly absorbs moisture
from the air. This lowers the boiling point of
the brake fluid. If the boiling point is too low,
vapour pockets may form in the brake sys‐
tem when the brakes are applied hard.
This impairs the braking effect.
Have the brake fluid renewed at the
#
specified intervals.
Have the brake fluid regularly replaced at a
qualified specialist workshop.
Only use a brake fluid approved by Mercedes-
Benz according to MB-Freigabe or MB-Approval
Capacity
331.0.
9.5 litres
Coolant
Notes on coolant
Observe the notes on operating fluids
( page 405).
/
& WARNING Risk of fire‑ and injury from
antifreeze
If antifreeze comes into contact with hot
component parts in the engine compart‐
ment, it may ignite.
Allow the engine to cool down before
#
you top up the antifreeze.
Make sure that no antifreeze spills out
#
next to the filler opening.
Thoroughly clean the antifreeze from
#
component parts before starting the
vehicle.
* NOTE Damage caused by incorrect cool‐
ant
Only use coolant that has been pre‐
#
mixed with the required antifreeze pro‐
tection.
Information on coolant is available at the fol‐
lowing locations:
in the Mercedes-Benz Specification for
R
Operating Fluids 310.1
at https://bevo.mercedes-benz.com
-
in the Mercedes-Benz BeVo app
-
at a qualified specialist workshop
R