Huawei LUNA2000-200KWH-2H1 Smart String ESS User Manual page 209

LUNA2000-200KWH-2H1 Smart String ESS
User Manual
Paint Damage
Deep scratch
(primer damaged,
steel base
material exposed)
Logo and pattern
damage
Dent
Procedure
Step 1 Gently polish the damaged areas using fine sandpaper to remove smudges or rust.
Figure B-1 Polishing a damaged area using sandpaper
Issue 02 (2023-02-28)
Tools and
Materials
Spray paint or
paint, zinc-rich
primer, fine
sandpaper,
anhydrous
alcohol, cotton
cloth, and brush
(required for
repainting a small
area) or paint gun
(required for
repainting a large
area)
If a logo or pattern has been
damaged, obtain the logo size and
color number and contact a local
advertisement coating supplier to
formulate a repair solution based on
the logo size, color, and damage.
1. If a dent is less than 100 mm
area and 3 mm in depth, fill the
dent with Poly-Putty base and then
perform the same operations as
those for fixing deep scratches.
2. If a dent is greater than 100 mm
area or greater than 3 mm in
depth, contact the local supplier for
an appropriate repainting solution.
Copyright © Huawei Digital Power Technologies Co., Ltd.
B Repainting the Equipment
Procedure
Steps 1, 2, 3, 4,
and 5
2
in
2
in
Description
large-area
smudges and
rust, use a
paint gun to
spray paint the
area.
4. The paint
coating should
be thin and
even. The
surface should
be smooth.
There must not
be any paint
drops on the
coating.
5. Leave the
repainted area
for about 30
minutes before
performing any
further
operation.
201