Table of Contents
Advertisement
Installation
Ceramic Liner Installation
The liners install in the manner outlined below with the
exception of the 2725RGL—Refl ective Glass Liners:
see instructions supplied with those liners.
Unpack the liner panels carefully.
Left
Left
end
rear
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors just enough to
allow them to rotate (one per side).
2. Place the right end panel against the right wall of the
fi rebox. Place the bottom edge in fi rst and carefully
press the panel to the outside wall. Rotate the right
panel anchor down and tighten its screw.
38
Roof
panels
Center
rear
Right
rear
Right
end
3. The rear panel is supplied in three sections which
are fi tted into each other. Two of the sections are
identical. Their stepped edges go towards the
middle to fi t into the middle section
4. Place the right rear panel into the rail at the rear of
the fi rebox, angled edge upward. Slide to the right
until it is tucked behind the right end panel.
Front
5. Place the center rear panel into the rail and slide it
to the right until it tucks behind the right rear panel.
Liner Installation
Rear
Advertisement
Table of Contents
