Enjoying Music In The Remote Zone - Onkyo TX-NR801 Instruction Manual

Enjoying Music in the Remote Zone—Continued
Input source
buttons
TUNING
PRESET
DIRECT / PURE AUDIO STEREO SURROUND THX DSP MEMORY FM MODE

Enjoying Music in the Remote Zone

Using the buttons on the TX-NR801/TX-NR801E
1 Press the ZONE 2 button on the
TX-NR801/TX-NR801E.
2
Select an input source.
After pressing the ZONE 2 button, you
DVD VIDEO 1 VIDEO 2
must press an input source button within
VIDEO 3 VIDEO 4 VIDEO 5
8 seconds. The indicator above the input
TAPE TUNER PHONO C D NET AUDIO
source button lights green. In this condi-
tion, even if you change the input source
for the main zone, the input source for the
remote zone (Zone 2) will not change.
Ex.: When the CD button is pressed.
To select the same source for the remote zone
that is selected for the main zone, press the
ZONE 2 button again until
"Z2 Sel:SOURCE" appears in the display. In
this condition, if you change the input source
for the main zone, the input source for the
remote zone (Zone 2) will change as well.
When "Z2 Sel:Off" is displayed, the
output to the remote zone is turned off.
3 Adjusting the volume, press the
TUNI NG
PRESET
Notes:
• If a sleep time is set with the SLEEP button, the output to the
remote zone will also turn off when the sleep time elapses.
• If the REC OUT button is pressed in the main room
while someone is using the system in the remote zone,
68
ZONE 2
ON
SETUP
ENTER
RCVR
RE TURN
A-FO RM LISTENING MODE MEMORY
LEVEL
/
INPUT
SELECTOR
buttons
ZONE 2
or cursor button.
the Zone 2 function will be deactivated and the source
will turn off in the remote zone.
• If you select FM (or AM) with the TUNER input
source buttons when the source for the remote zone
(Zone 2) is set to AM (or FM), the output for the
remote zone also changes to AM (or FM).
• 7.1 channel playback in the main room is disabled if the
Surr Back/Zone 2 setting in the Surr Back/Zone 2 sub-
menu of the Hardware Setup Menu is set to "Zone 2."
• When you are using the remote zone (Zone 2), the
system operation will not work.
• When you are using the remote zone (Zone 2), the
Pure Audio setting will not work.
• When you are not using the remote zone (Zone 2),
press the ZONE 2 button and then press the OFF
button to turn off the ZONE 2 indicator. (Using the
remote controller, press the ZONE 2 button and
then the STANDBY button.)
Using the remote controller
Before performing the procedures, press the RCVR but-
ton to enter the receiver mode.
To turn on the TX-NR801/TX-NR801E from the remote zone:
After pressing the ZONE 2 button,
press the ON button within 5 sec-
onds.
Be sure to press the ON button while the
RCVR button lights.
Select an input source:
After pressing the ZONE 2 button,
press an INPUT SELECTOR button
within 5 seconds.
If tuner is selected with the TUN button,
you can use the CH
a preset radio station.
Adjusting the volume for the remote zone:
After pressing the ZONE 2 button,
press the LEVEL
Note:
After you press the ZONE 2 button on the remote controller, the
STANDBY indicator on the TX-NR801/TX-NR801E flashes
for five seconds. During this time, you will not be able to per-
form operations in the main zone using the remote controller.
button to select
/ button.