Playing Analog Multichannel Audio - Onkyo TX-NR801 Instruction Manual

Enjoying Analog Multichannel Audio Playback—Continued

Playing Analog Multichannel Audio

Before enjoying analog multichannel audio, make sure
that the connections and settings shown on the previous
page are completed.
The illustrations used here represent the remote control-
ler. When you perform the procedures on the
TX-NR801/TX-NR801E, use the corresponding buttons
on the front panel.
1 Press the input selector button.
2
Select "Multich" using the AUDIO
SELECTOR button on the front
panel (or AUDIO SEL button on the
remote controller).
3 Turn on the connected component
and start playing the desired media.
4 Adjust the volume with the MAS-
TER VOLUME dial (or the VOL
buttons on the remote controller).
Adjusting the output level of each speaker as desired
Using the remote controller:
1 Press the RCVR mode button.
2 Press the CH SEL button and
select the desired speaker.
3
Press the LEVEL
adjust the volume level.
Adjust the volume at each speaker so that
all the volumes sound at the same level at
the listening position. For the front right,
front left, center, surround right, sur-
round left, surround back right, and sur-
round back left speakers, the output
levels can be adjusted between –12 and
+12 decibels. The subwoofer can be
adjusted between –30 and +12 decibels.
Note:
The speaker level for each multichannel analog input is
independent from the speaker level settings made with
the test tone. Therefore, you should perform the proce-
dures above before enjoying analog multichannel audio.
Changing the listening mode
Using the tone control
1
TX-NR801/
TX-NR801E
Remote
controller
2
To disable the tone control function:
Press the DIRECT/PURE AUDIO button on the front
panel (or the DIRECT button on the remote controller).
or button to
Each time you press the DIRECT/
PURE AUDIO button on the front
panel, the display changes
between "Direct"
When using the remote controller,
press PURE A or DIRECT.
Press the SURROUND button on
the front panel (or the SURR but-
ton on the remote controller) to
display "Tone On."
SURROUND
Adjust the bass and treble sounds.
Select "Setup Menu" → "Audio Adjust
Menu" → "Tone Control" to display the
"Tone Control" sub-menu and perform
the bass and treble settings. For details,
see page 54.
"Pure Audio."
65