Connecting The Power; Turning On The Power; Turning On The Power From The Remote Conroller - Onkyo TX-NR801 Instruction Manual

Connecting the Power

(USA, Canadian and Australian models)
STANDBY/ON
STANDBY indicator
DIRECT / PURE AUDIO STEREO SURROUND THX DSP
• Before you plug in the TX-NR801/TX-NR801E, con-
firm that all connections have been made properly.
• Turning on the power may cause a momentary power
surge, which might interfere with other electrical
equipment on the same circuit, such as computers. If
this happens, use a wall outlet on a different circuit.
(All models other than USA, Canadian and Austra-
lian models)
• The TX-NR801/TX-NR801E is shipped with the
main power (POWER) switch in the on position
( ). When the power cord is plugged in for the
ON
first time, the TX-NR801/TX-NR801E will automati-
cally enter the standby state and the STANDBY indi-
cator will light (same condition after step 2 below).

Turning on the Power

1
Plug the power cord into an AC
wall outlet.
(USA, Canadian and Australian
models)
STANDBY
The STANDBY indicator will light up.
(Other models)
POWER
Press the POWER switch to set the
TX-NR801/TX-NR801E to standby
ON OFF
state.
STANDBY
The STANDBY indicator will light up.
2
Press the STANDBY/ON button to
turn on the TX-NR801/TX-NR801E.
STANDBY/ON
The display will light up and the
STANDBY indicator will turn off.
If you press the STANDBY/ON button
STANDBY
again, the TX-NR801/TX-NR801E
returns to the standby state.
Turn off
(Other models)
STANDBY/ON
STANDBY indicator
SETUP
TUNING
ENTER
RE TURN
PRESET
MEMORY FM MODE A-FO RM LISTENING MODE MEMORY
To wall outlet
POWER
SETUP
TUNING
ENTER
RE TURN
PRESET
DIRECT / PURE AUDIO STEREO SURROUND THX DSP MEMORY FM MODE A-FO RM LISTENING MODE MEMORY
To wall outlet
Turning on the Power from the
Remote Controller
Before you can use the remote controller, you must
perform steps 1 and 2 above and place the TX-NR801/
TX - NR801E in the standby state.
1
Press the RCVR MODE button.
The RCVR MODE button lights.
2 Press the ON button to turn on the
TX-NR801/TX-NR801E (take it out
of the standby state).
To return the TX-NR801/TX-NR801E
to the standby state, press the
STANDBY button.
Memory backup
The TX-NR801/TX-NR801E uses a battery-less mem-
ory backup system in order to retain radio presets and
other settings when it is unplugged or in the case of a
power failure. Although no batteries are required, the
TX-NR801/TX-NR801E must be plugged into an AC
outlet in order to charge the backup system.
(On other than USA, Canadian and Australian models,
the TX-NR801/TX-NR801E's POWER switch must be
set to ON in order to charge the backup system.) Once it
has been charged, the TX-NR801/TX-NR801E will
retain the settings for several weeks, although this
depends on the environment and time will be shorter in
humid climates.
ON
STANDBY
RCVR
27