Configuring Input Settings Suitable For Your Connections; To Change The Display Of The Input Source From Tape To Md - Onkyo TX-NR801 Instruction Manual

Selecting the Appropriate Setting
for Your Connections—Continued
• To accurately set the output levels, it is recommended
to use a handheld sound pressure level (SPL) meter.
Set the meter to C-weighting and slow averaging. A
®
Radio Shack SPL meter or equivalent is
recommended. Using the internal channel noise
generators, set each channel so that you read a 75
decibel sound pressure level.
Using the remote controller
1
Press the TEST button.
A pink noise will be emitted from the
front left speaker.
At this time, the volume of the pink noise
will automatically increase to a
predetermined reference level (0 dB).
2
Remember the volume level of this
noise and then press the CH SEL
button.
The TX-NR801/TX-NR801E will now
emit the pink noise from the center
speaker.
3
Using the LEVEL
adjust the volume level of the
noise from the center speaker so
that it is at the same level as that
emitted from the front left speaker.
4
Use the CH SEL and LEVEL
buttons to select other speakers
and adjust the volumes until all
speakers are adjusted to the same
level.
5 Press the TEST button to complete
the procedure.
Configuring Input
Settings Suitable for
Your Connections
These input settings should be made so that the
TX-NR801/TX-NR801E is optimized for your connec-
tions. If the default settings suit your connections, you
do not need to change any settings.
To Change the Display of the Input
Source from TAPE to MD
If you connected an MD recorder to the TAPE jack on
the TX-NR801/TX-NR801E, you can have "MD"
appear when the TAPE source button is pressed.
TX-NR801/
/ buttons,
TX-NR801E
Remote
controller
/
DIRECT / PURE AUDIO STEREO SURROUND THX DSP MEMORY
TAPE TAPE
Press and hold down the TAPE
source button on the TX-NR801/
TAPE TX-NR801E until the display
changes from TAPE to MD (approx.
3 seconds).
When you use the remote controller to
perform the procedure, on the remote
controller, press the RCVR button and
hold down the TAP button for three sec-
onds.
To return the display to its original
setting, perform the same procedure.
SETUP
TUNING
ENTER
RE TURN
PRESET
FM MODE A-FO RM LISTENING MODE MEMORY
35