Installing A Card In A Full-Length Slot - Epson ActionPC 5000 User Manual

before you install it. (See the option card instructions.) Also,
see if you need to change any jumpers on the system board,
such as jumper J15, which determines the wait states for
your VESA slots. See page 4-7 for more information.

Installing a Card in a Full-length Slot

Refer to the illustration below and follow these steps to install
an option card in one of the full-length slots:
1. Remove the retaining screw securing the option slot cover
to the computer, as shown below. (Keep the screw to secure
the option card to the computer.)
2.
Slide out the slot cover and set it aside. (Store it in a safe
place in case you remove the option card later.)
3.
Hold the card along the top comers and guide it into the slot,
as shown below. (If you are installing a full-length card,
insert the front edge of the card into the corresponding
guide inside the computer's front panel.)
Installing and Removing Options
4-17