Installing The Assist Handle - Toro 161-4450 Manual

1. Mark and drill holes here.
3. Drill holes at the marked locations using a drill
bit (9/32 inch) as shown in
WARNING
Using a drill without proper eye
protection may allow debris to enter the
eye, causing injury.
When drilling, always wear eye
protection.
Securing the Bracket to the Frame
Rail
Secure the bracket to the side of the left frame rail
using 2 thread-forming hex flange-head bolts.
1. Hex flange-head bolt (thread-forming—5/16 x 3/4 inch)
Figure 3
2. Left frame rail
Figure 3.
Figure 4

Installing the Assist Handle

1. Align the lower hole in the assist handle with
the closed slot in the assist-handle bracket as
shown in
g465023
1. Washer (3/8 inch)
2. Retaining ring
2. Assemble the grooved pin through the slot in
the bracket and the hole in the assist handle
(Figure 5).
3. Secure the pin to the bracket and handle with
the washer (3/8 inch) and the retaining ring
(Figure 5).
g465027
3
Figure 5.
Figure 5
TimeCutter model shown
3. Pin (grooved)
g465144