Table of Contents
Advertisement
1
Preparing the Mower
No Parts Required
Procedure
Perform the following procedure to prepare the mower for
attaching the blower and finishing kit.
1. Disengage the PTO, move the motion-control levers
to the N
-
EUTRAL
LOCKED
brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Pull the spark plug wires.
4. Repair all bent or damaged areas of mower deck and
replace any missing parts.
5. Clean the mower of any debris on the deck or rear part
of the mower to ease installation.
position and set the parking
2
Installing the Side Bumpers
Parts needed for this procedure:
1
Left bumper
1
Right bumper
2
Carriage bolt (3/8 x 1-1/4 inches)
6
Flange nut (large flange–3/8 inch)
Procedure
1. Remove the nuts and bolts holding the side bumpers
to the machine
(Figure
Note: Discard all nuts and only the 1 bolt removed
from each side
Note: For 60- and 72-inch mowers, do not install the
bolt and flange nut for the left bumper near the ROPS.
You will install them when you install the handle
bracket in a following procedure.
2. Install the new left and right bumpers with 2
carriage bolts (3/8 x 1-1/4 inches), 4 previously
removed carriage bolts, and 6 flange nuts (3/8 inch) as
shown in
Figure
1. Flange nut (large
flange–3/8 inch)
2. Right bumper
3. Use existing bolts
8
5).
5.
Figure 5
4. Left bumper
5. Bolt (3/8 x 1-1/4 inches)
Advertisement
Table of Contents
