About Roll Paper Cutting - Epson Stylus Pro 4900 User Manual

Epson Stylus Pro 4900/4910

About Roll Paper Cutting

When performing borderless printing on roll paper, you can specify whether it is left and right borderless printing or
all edges borderless printing, and how to cut the paper in the printer driver's Roll Paper Option. The cutting operation
for each value is shown in the following chart.
Printer driver
Normal Cut
settings
Cutting Operation
The default printer driver setting
is Normal Cut.
Explanation
User's Guide
Printing Varieties
Single Cut
❏
❏
❏
70
The top area may become
slightly uneven depending
on the image since the print
operation stops while
cutting the top edge of the
roll paper.
If the cut position is
misaligned slightly, small
parts of the image may be
shown on the top or
bottom of the adjacent
pages. If this occurs,
perform Cutter
Adjustment.
"Maintenance menu"
U
on page 105
When printing only one
page the operation
performed is the same as
that for Double Cut. When
continuously printing
multiple sheets, the printer
cuts 1 mm inside on the top
edge of the first page and
the bottom edge of the
subsequent pages to avoid
showing margins.
Double Cut
❏
The top area may become
slightly uneven depending
on the image since the print
operation stops while
cutting the top edge of the
roll paper.
❏
The printed paper is
approximately 2 mm
shorter than the specified
size since the printer cuts
the paper inside the image
to avoid showing top and
bottom margins.
❏
After cutting the bottom
edge of the previous page,
the printer feeds the paper,
and then cuts the top edge
of the following page.
Although this produces 80
to 127 mm cut-off pieces,
the cut is more accurate.