Network Setup Menu; Spectroproofer Menu - Epson Stylus Pro 4900 User Manual

Epson Stylus Pro 4900/4910

Network Setup menu

You can make settings for the network connection. After setting the items, press the l button to return to the previous
screen, and then the network is reset and a network connection is available after 40 seconds. This setting is not
displayed while resetting.
The factory setting is
Item
Network Settings
IP Address Setting
IP,SM,DG Setting
Bonjour
WSD
Init Network Setting

SpectroProofer menu

These settings are only available when the optional SpectroProofer is installed.
Item
SpectroProofer
User's Guide
Using the Control Panel Menu
.
Parameter
Hide
Show
Auto
Panel
You can set the IP address, Subnet Mask, and Default Gateway. Contact your system administrator
for detailed information.
On
Off
Off
On
Execute
Parameter
Status Information
Explanation
The following items only appear when Show is selected.
Select whether to use DHCP to set the IP address (Auto), or to set
the address manually (Panel). When you select Panel, the
IP,SM,DG Setting below is displayed.
Select whether the network interface uses Bonjour (On) or not
(Off).
Select whether the network interface uses WSD (On) or not (Off).
You can restore the network settings to the factory settings.
Explanation
Displays the status for each item (Device Version:ILS20EP,
Calibration Tile S/N, Device Temperature, Firmware Version, Air
Temperature, Backing Color, and Calibration Status) of the
installed SpectroProofer. However, when the printer is in sleep
mode, the temperature or the air temperature are not displayed.
111