Cutting The Roll Paper - Epson SureColor SC-F6300 Series User Manual

SC-F6300 Series User's Guide
F
Lower the roll paper lock lever, and then press the
Z button.
If the leading edge of the paper is not horizontal
or not cut neatly, you can cut the edge of the roll
paper with the built-in cutter by pressing the Z
button, and then pressing the ) button within
five seconds.
G
Close the roll paper cover.
H
Check the paper type.
The previous settings for the paper type and
amount remaining are displayed.
To print using the current settings, press the d/u
buttons to highlight Keep Settings Above, and
then press the Z button.
Failure to set the appropriate paper type could
cause problems with print quality. See the
following for details on paper type and amount
remaining settings.
"Settings for Loaded Paper" on page 28
U

Cutting the roll paper

Either of the following two methods can be used to cut
roll paper after printing.
❏ Auto Cut:
Cut the roll paper after printing each page
automatically using the built-in cutter.
Basic Operations
❏ Manual cut:
Press the ) button to cut the paper using the
built-in cutter. A cutline is printed for manual
cutting and can be used as a guide when cutting
paper using the built-in cutter.
Note:
❏ It may take a while to cut the roll paper.
❏ Some of the roll paper may not be cut using the
built-in cutter. Use a cutter sold at a store to cut the
paper.
Follow the steps below when using a third-party
cutter.
Press the ) button. Keep the d button pressed to
feed the paper so that the cut location is below the
paper eject guide. Cut the paper using scissors or a
third-party cutter.
Setting methods
Use the l/r buttons in the control panel to select the /
tab and press the Z or Menu button. When the Setup
menu is displayed, select Printer Setup > Roll Paper
Setup > Auto Cut > On, and then press the Z button.
For manual cutting, select Off. The default setting is
On.
"Setup menu" on page 54
U
Manual cut method
If Auto Cut is turned Off, you can cut at any position via
the following procedure after printing is complete.
Buttons that are used in the following settings
26